Caution: Please do not take out the hard drive when DVR is running or connected to power!
- Cut power firstly, and then remove screws on both sides and rear panel and open DVR upper cover.
- Connect HDD data line and power line to the main board. Install the HDD to fix it on the bracket and then connect the HDD power line and the data line.
- Put the upper cover back carefully
Note: If the user requires higher performance HDD, it is strongly recommended to use a special hard drive for security and protection.
IP Camera and Monitor Connection
DVR video output signals are transmitted to VGA monitor or HDMI monitor by VGA or HDMI cable, and DVR video can be monitored (Refer to section 1.2 Rear Panel). Refer to Chapter 6 System Connection Diagram.
Power Supply Connection
Please use attached power adapter to connect DVR. Before power on, make sure the cables on the audio and video I/O ports and network port are well connected. For audio ports, please use a microphone and other audio devices together with BNC connecting a line to input or output audio signals.